Chamsys MagicHD Bedienungsanleitung PDF herunterladen (Seite 32)

MagicHD User Manual 24 / 58

Layer 2 + =

Output Layer

Note that it is not actually necessary to use the mask on layer 1, since layer 2 overlays it anyway. The effect of the mask in layer

1 is that as layer 2 is faded out, layer 1 retains the black masked out area.

5.2.3 Notes

Whatever the aspect ratio of an image used as a mask, its “screen” is the extent of the media for that layer. If the mask is stretched

to Fill X & Y it will ﬁll the area occupied by the media, not necessarily the whole screen. This can be overridden by the mask

stretch parameter for the layer.

5.3 Audio

MagicHD can play most common audio formats directly. Audio ﬁles should be added just like any other media.

If audio is present in a movie ﬁle, it will automatically be converted to the correct format when the media is converted (even if

the video is already in the correct format). MagicHD will then play the audio content if the following criteria are met:

Parameter Value

Direction Forwards

Speed Normal (i.e. +1.0)

Mode Once, Once+Black, Loop

Gain > 0

Intensity > 0

Audio Codec 16 bit PCM

MagicHD does not play audio backwards or at different speeds, so Play Mode or speed that are not compatible will result in the

audio output stopping for that layer.

5.3.1 Media Layers

Each media layer has an audio gain and an audio pan control. Gain sets the level for audio playback and should be used to

balance the volume of the clip against other clips in the show. It can be used to boost quiet clips or attenuate loud ones. Pan

moves the stereo signal from left to right. The volume for each media layer is automatically faded with the layer’s intensity.

Sections of audio-only media can be selected using the start and end frames, just like any other media. In this case MagicHD

uses a simulated 25 frames-per-second.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 65 66

Keine Kommentare

Chamsys MagicHD Bedienungsanleitung Seite 32