ChamSys MagicQ Bedienungsanleitung PDF herunterladen (Seite 37)

ChamSys Ltd www.chamsys.co.uk

MagicQ User Manual 37 Version 1.3.0.0

6 Setting Dimmer levels

The levels of Dimmers are controlled from the Intensity Window. Press the INT button to open the

window.

6.1 Using the on screen faders

This window displays a fader for each dimmer and head patched onto the console. Pressing the slider part of

the fader sets the appropriate level. When a fader is moved from 0 the channel in the programmer is

activated – and the fader will turn red.

The SQUARE OFF soft button enables fast programming of intensities. Using the touch screen select the

channels you wish to have at full and at zero – but don’t bother being exactly accurate with the level of the

selection. Pressing SQUARE OFF finishes the job by setting all channels that are less than 50% to 0 whilst

setting channels above 50% to full.

Use the ALL TO FULL and ALL TO ZERO buttons to change the level of all the channels.

Press SHIFT and SQUARE OFF to invert the faders - all channels less than 50% go to 100% whilst all

channels above 50% go to 0%.

Press the CLEAR soft button to clear the programmer.

6.2 Using the encoders

A single fader or multiple faders can be controlled using the top right rotary encoder. The encoder controls

the fader, which the cursor is over. Selecting a block of faders by pressing the cursor keys whilst holding the

SHIFT button down enables multiple faders to be selected.

6.3 Using the keypad

The level of dimmers and the intensity channel of heads can be set from the keypad. Head numbers are used

to reference the required dimmers and heads.

If you intend to use this method for setting intensities then you should set up the head numbers when

patching. It is easy to do - the console can automatically renumber them, or they can be set to be the same as

the DMX start address of the dimmer / head. See the section on patching.

Keypad setting of intensities is supported regardless of which Window is currently active.

To set heads 1 to 4 to 40% key in

1 THRU 4 @ 40

To set heads 1 to 4 and heads 8 to 11 to 100% key in

1 THRU 4 + 8 THRU 11 @ FULL

To set heads 1 through 12 but not head 7 to 10% more than their current value key in

1 THRU 12 - 7 @ +10

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 138 139

Keine Kommentare

ChamSys MagicQ Bedienungsanleitung Seite 37